In our daily life, hair transplanting processing has gradually become very common, so what are the operating procedures of the hair transplanting machine? The voltage regulator output 200 volts AC is supplied to a 100 kV transformer, Brush Machine one end of the transformer is grounded, and the other end is connected to the screen inside the wooden box.
Put the bucket filled with glue into the stirring bucket, then tighten the lid of the bucket, then connect the air source and the spray gun, and then turn on the gas source, let the fan blades in the stirring bucket stir the glue evenly . Put the plastic parts that need to be planted into the glue mold,Brush Machine and then put it into the suction box, open the spray box, spray a lot of glue on the glue parts, and then take the glue parts out of the glue mold , And then put it on the wooden stick.
Put the wooden stick into the tufting box, step on the switch, connect the power supply, and make the screen under the high voltage of static electricity to suck up the fluff. Then, turn the part where the hair needs to be planted downward and swing it against the fluff constantly, so that the fluff can reach an average over a period of time,Brush Machine and the plastic parts can be absorbed sufficiently. Put the rubber parts that have been planted into the furnace together with the wooden stick to dry the glue. Take out the wooden stick from the furnace, and then take out the plastic parts from the wooden stick and put them away. After the plastic parts are cooled to normal temperature, we start to count the appearance of the hair.
Matters needing attention in hair transplanting: every shift of the hair transplanting machine should add lubricating oil to the moving parts to reduce mechanical wear. Check the screws regularly for looseness, and lock them in time. Keep the guide rail and the screw rod clean to prevent debris from adhering to the guide rail or the screw rod, which affects the positioning accuracy. Ensure that the electric box is in a ventilated environment,Brush Machine avoid humid or high temperature environments, and prevent the electric box from violent vibration. The electric box can no longer be in the environment of strong electromagnetic fields, otherwise it may appear uncontrolled. The input power wiring must be correct (red, blue, and yellow wires are connected to 380 volt three-phase wires, green wire is connected to the neutral wire, and yellow-green interphase wire ground wire), pin numbers: 1, 2, 3 are 380V phase wires, 4 neutral wires ,Brush Machine 5 ground wire. The voltage should be stable and keep at AC380 + -10V. Excessive voltage may cause the original electronic parts to burn out.
It is forbidden to hit the touch screen with hard objects, otherwise it will cause the sensitivity drop and even break the glass screen. Do not pull the cable too hard. There is high-voltage electricity in the electric box. Non-professionals are not allowed to disassemble in case of failure to prevent electric shock or even destroy system data.