Automatic processing: It means to process products continuously without stopping in the middle. Unless you press the "Stop" button, only when more than two fixtures are placed, Brush Machine can the product be processed circularly. Fully automatic processing can improve production efficiency. When the product on the first fixture is processed and the product on the second fixture is processed, the product on the first fixture can be replaced, and when the product on the second fixture is processed, You can replace the product on the first fixture to achieve reciprocating processing. If only one fixture is placed, only semi-automatic processing mode can be used. In the standby state, Brush Machine press the number key "1" on the panel to enter the full-automatic working mode. When protection occurs, the entire mechanical action stops. After repairing, move the machine head to a high position and use the "single step" key to find Press the "Start" key to process the vacant position. Otherwise, in the original hole position, pressing the start key will cause heavy holes, Brush Machine which may damage the needle. Be careful when operating, and also pay attention to semi-automatic processing.
Semi-automatic processing: Press the "Start" key once to process once. After processing the product, the machine head stops at the highest position and runs to the starting point. Replace the product, press the "Start" key again, run to the first hole, and process again, you can also start processing from the Nth hole to the last hole, N can be set, you can enter the hole number through the keyboard, press The upper hole and lower hole keys run to the hole to ensure that the hole position has not been processed, and then press the "start" key to process, otherwise the needle will be damaged. When protection occurs, the processing method is the same as that of the fully automatic processing.
Fully automatic test machine: After teaching the product data, press the "Upper hole" or "Down hole" button on the automatic test machine screen to realize single-step hole alignment, you can find out if the hole position is wrong,Brush Machine if there is any , You can quit and enter the teaching edit interface to modify. After pressing Start, the workbench will continue to move until a product program file is completed and the work stops, so you can test whether the workbench is normal.